In the process of charcoal production mechanism of mechanism charcoal machine, attention will be paid to the occurrence of charcoal, which affects the quality of mechanism charcoal and the use of equipment, but also creates a lot of losses and waste for enterprises. What are the factors that cause such a situation in the use of mechanism charcoal machine production mechanism charcoal?
1. The airflow in the kiln is not smooth.
2. Kiln manufacturing problems.
Solutions to the problem of carbon generation in mechanism charcoal machine:
1. Air flow is not smooth: the main reason is that the flue is not placed properly, the cracks of the bricks are too large, and the sawdust sticks fall into the flue to block the flue. Such problems can only be eliminated by preventing and supervising the work of kiln loaders. It's really impossible to replace it with a grate flue.
2. Kiln manufacturing problems: Generally speaking, kilns are not built according to the requirements. Four corners are not built into rounded corners, which usually cause such problems. As mentioned earlier, the main heat conduction mode in kilns is air convection. If the four corners are right angles, it is difficult for air to flow to the location, so that heat can hardly be transmitted to the location, and the location will generate charcoal. Only if the four corners are right angles. The solution is not to place the sawdust stick in this position.
When using mechanism charcoal machine to produce mechanism charcoal, operators should find out the reasons, prescribe symptoms and make corresponding treatment, so as not to affect the production progress of mechanism charcoal machine, but also to ensure the quality of produced mechanism charcoal.